Installing a shower base is a crucial step in creating a functional and beautiful shower space. Vasca Design offers high-quality shower bases that combine style with durability. Follow these steps to properly install your Vasca shower base:
- Preparation: Gather all necessary tools and materials, including the Vasca shower base, level, pencil, tape measure, drill, screwdriver, silicone caulk, mortar mix, trowel, and shims. Carefully unpack and inspect the shower base for any damage.
- Check the subfloor: Ensure the subfloor is level, clean, and free of debris. Use a self-leveling compound if needed to create a smooth surface. The subfloor must be sturdy enough to support the weight of the shower base, water, and users.
- Dry fit the shower base: Place the Vasca shower base in its intended location and use a level to check that it’s perfectly level in all directions. Mark areas that need adjustment.
- Prepare the mortar: Mix the mortar according to the manufacturer’s instructions.
- Apply the mortar: Spread an even 1/2 inch layer of mortar on the subfloor where the shower base will sit using a trowel.
- Set the shower base: Carefully lower the Vasca shower base into place, pressing it firmly into the mortar bed. Use a level to ensure it’s perfectly level in all directions. Adjust if needed using a rubber mallet.
- Allow mortar to set: Leave the shower base undisturbed for at least 24 hours to allow the mortar to set completely.
- Install the drain: Once the mortar has set, install the drain according to the manufacturer’s instructions. Apply silicone caulk around the drain flange before tightening to create a watertight seal.
- Secure the shower base: If required, use corrosion-resistant screws to attach the flange of the base to the wall studs through pre-drilled holes.
- Apply silicone caulk: Run a bead of silicone caulk along the edges where the shower base meets the walls to create a watertight seal.
- Install shower walls: Once the caulk has dried, proceed with installing your shower walls according to the manufacturer’s instructions.
- Final inspection: Perform a final check to ensure all seals are watertight and the base is level. Test the drainage by running water in the shower.
By following these steps, you can successfully install your Vasca Design shower base, creating a sturdy and watertight foundation for your new shower. Always consult the specific installation instructions provided with your Vasca shower base, as details may vary depending on the model.
